Click image to zoom.
Shown image is ilustrative only. Please refer to manufacturer's website and/or available datasheet for accurate information.
This starter kit kit contains everything you need to start making single and double-sided PCB's in just a few minutes... transfer paper, copper laminate and sealing foils.
The only other items you'll need are a bowl of water, paper towel, etchant of your choice and a small can of acetone to remove the toner and foil "resist" image from the board after etching.
With this starter kit and recommended applicator (GBC laminator) you will have the ability to make high density, high quality single and double-sided PCB's first time, every time in just a few minutes. Plus you can do it without using an etching tank too!
The starter kit includes the following replenishable items plus unlimited Pulsar email and telephone support from 9am ~ 5pm EST.
Also included is a special custom printed set of circuit test images on a sheet of the transfer paper. It is used as a guide to compare to the quality of the printouts from your laser printer or copier. Pages are printed from a known good "density" of toner. Also can identify if your laminator is not performing as expected. Click on image to zoom
Click on the image to zoom.
